Presentation Of The Product - Look 675 Manual De Montaje

EN
Congratulations!
You have chosen a LOOK frame set.
We thank you for your confidence in our
products. By choosing this new looK frame
set, you are about to enjoy the advantages of
a high-technology product of French design.
Your LOOK 675 frame, fork, A-Stem and
carbon seat post are identical to those
supplied to the large professional teams,
are checked throughout the manufacturing
process and will give you complete
satisfaction.
Our products conform to the various current
European and international standards.
We advise you to contact a professional,
when fitting accessories.
Before use, please read these instructions
fully and follow the advice they give, in
order to benefit fully from the features of
this top-quality product.
LOOK reserves the right to change product
specifications without prior notice.
16

PresentatIOn OF tHe PrOduCt

Your 675 frame set has been designed
and developed to specifications issued
by the LOOK R&D department in order to
offer the best transmission of force and
unprecedented steering precision.
These two characteristics are possible due
to the integration of components specifically
designed for this frame. They are therefore
perfectly mutually compatible, offering
improved overall coherence and enhanced
performance.
Important:
This LOOK frame is designed and
optimized to be used by cyclists who do
not weigh over 100 KG (220 lbs.)
When fitting the a-stem, please refer to the
instruction specific to this product.
Your frame is delivered with a pre-mounted
HSC 675 fork with its LOOK Head Fit 4 head-
set.
The fork is delivered fitted to the frame with
a steerer tube of a length specific to each
head tube. The steerer tube is 5 mm longer
on purpose in order to provide the possibility
of fitting a 5 mm spacer under the stem. If
you want to fit the A-Stem in the lower posi-
tion and fully adhere to the overall design, it
is necessary to cut down the steerer tube by
5 mm in order (cut indicator on the steerer
tube).
It is strongly advised that you go to an ap-
proved LOOK retailer to have this cut made.
Since the A-Stem is designed for perfect
integration into the frame, we recommend it
be used as far as possible without a spacer
under the stem. To adjust the height of the
handlebar, all you have to do is to turn the
reversible A-Stem.
NOTE:
Since the adjustment of the height of the stem is independent of the tightening of the headset, and
the assembly of the fork with its headset requires specific tools, it is strongly advised that you go to
an approved LOOK retailer to have the fork dismantled or re-fitted fully and correctly.
For all maintenance operations we remind you that the fork must be fitted to a wheel. Abnormal wear
on the fork ends resulting from scraping on the ground are not covered by the LOOK warranty.
EN
The A-Stem is available in two different
angulations (+/- 5 mm and +/- 15 mm) and in
five lengths: 80 mm / 90 mm / 100 mm / 110
mm / 120 mm, which allows wide options as
regards the adjustment of one's handlebar,
without damaging its integration.
For even finer adjustments, one can add a 5
mm spacer between the stem and the elas-
tomer. The stem will then exceed the frame
by 5 mm, slightly reducing the integration
effect, but providing finer adjustment. The
system is optimal without spacer because
the stem is attached as closely as possible
to the bearings on the shortest possible
steerer tube.
Without spacer With 5 mm spacer
(uncut steerer tube)
17