body Power BRM8981 Manual Del Usuario página 12

A s s e m b l y S t e p 8
A. Remove the three Washers (#30) and three Nylon Nuts (#17) that are
pre-assembled on the bottom of the Seat (#70) and set them aside as they
will be used later in this step.
Attach the Seat (#70) onto the Horizontal Seat Bar (#69) and make sure
that the single point of the Seat (#70) is pointing forward as illustrated
below and then secure with the three Washers (#30) and three Nylon Nuts
(#17) that were previously removed.
Secure the Horizontal Seat Bar (#69) to the Seat Post (#65) using one Knob
Nut (#66) inserted through one Washer (#72). The Knob Nut (#66) can be
loosened to adjust the distance of the seat from the handle bars. Make sure
to tighten the knob after making any adjustment.
If pre-assembled, remove the Knob Bolt (#63) on the mouth of the Main
Frame (#60). Insert the Seat Post (#65) into the mouth of the post that is
protruding from the Main Frame (#60) down a minimum of 4 inches to
engage the lowest hole. Make sure the holes on the Seat Post (#65)
are facing the front before inserting. Secure the Seat Post (#65) (now
with Seat (#70) attached) using the (previously removed) Knob Bolt (#63).
Connect the AC Adapter (#71) into the female socket at the back of the unit.
Note: This power unit is intended to be correctly orientated in a vertical or
floor mount position
Troubleshooting
HAND PULSE SIGNAL
After complete assembly: If the computer is not picking up your hand pulse signal (or you are getting
inaccurate readings), Please refer to our "Troubleshooting" section on Page 18 for other troubleshoot issues.
BRM8981
Assembly Instructions
#42 WASHER FOR M10 BOLT,T2.0 1PC
Hardware Required
Washers
#30. Washer (d8xφ16x1.5 mm) [3 Pieces]
#72. Washer (d10xφ20x2.0 mm) [1 Piece]
Nuts
#17. Nylon Nut (M8xH7.5xS13 mm) [3 Pieces]
Others
#63. Knob Bolt (M16x1.5x15xφ49 mm) [1 Piece]
#66. Knob Bolt (M10xφ58x32 mm) [1 Piece]
ASSEMBLY IS NOW COMPLETE. HOWEVER, PLEASE
READ ALL SAFETY GUIDELINES & WARNING LABELS
BEFORE USING THE UNIT TO AVOID SERIOUS INJURY.
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust seat simultane-
ously
Push knob back inward until it clicks and then
tighten it by turning clockwise.
W A R N I N G
Do not remove the Seat (#70) for any
reason after you have installed it.
Exercising on this unit without the Seat
(#70) can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
Page 11