body Power BRM8981 Manual Del Usuario página 9

A s s e m b l y S t e p 3
A. Please use illustration "A" below as reference.
On the left side, ensure that one Special Washer (#20) is present (already pre-
assembled) on the Center Post (#28). (Note: Please be careful not to dispose of
Special Washers (#20) when removing the protective packaging.)
Then slide on the Left Coupler Bar (#25L), followed by one Washer (#23), one
Spring Washer (#10), and secure with one Hex Bolt (#22).
On the right side, ensure that one Special Washer (#20) is present (already pre-
assembled) on the Center Post (#28).Then slide on the Right Coupler Bar
(#25R), followed by one Washer (#23), one Spring Washer (#10), and secure
with one Hex Bolt (#22).
B. Referring to close-up illustration "B", align the holes on the Left Coupler Bar
(#25L) to the front of the Left Pedal Tube (#36L) by inserting one Hex Bolt (#35)
through the Left Pedal Tube (#36L), the Left Coupler Bar (#25L) and secure with
one Washer (#30) and one Nylon Nut (#17). Repeat this process on the right side.
A A
BRM8981
Assembly Instructions
Hardware Required
Bolts
#22. Hex Bolt (M8x16xS14 mm) [2 Pieces]
#35. Hex Bolt (M8x75x13xS14 mm) [2 Pieces]
Washers
#10. Spring Washer (d8) [2 Pieces]
#23. Washer (d8xφ32x2.0 mm) [2 Pieces]
#30. Washer (d8xφ16x1.5 mm) [2 Pieces]
#20. Special Washer (d19xφ25x0.3 mm) [2 Pieces]
Nuts
#17. Nylon Nut (M8xH7.5xS13 mm) [2 Pieces]
B
Page 8