body Power BRM8981 Manual Del Usuario página 8

A s s e m b l y S t e p 2
A. With the help of an assistant, slide the Main Frame Shroud 2
(#57) onto the Center Post (#28).
B.
Next, connect Monitor Wire (Lower) (#59) to Monitor Wire
(Middle) (#50). Then, slip on the Center Post (#28) (with Main
Frame Shroud 2 (#57) now also attached) over the front protruding
post of the Main Frame (#60).
To attach the Center Post (#28), lift up the Main Frame Shroud 2
(#57). Secure the back of the post using two Bolts (#29) and
two Washers (#30); and then secure the front of post using two
Bolts (#29) and two Arc Washers (#31). Secure the left and right
sides using two Bolts (#29) and two Washers (#30).
You may now gently release the Main Frame Shroud 2 (#57)
(which should cover the Bolts and Washers).
A
BRM8981
Assembly Instructions
B
Hardware Required
Bolts
#29. Bolt (M8x16xS6 mm)
[6 Pieces]
Washers
#30. Washer (d8xφ16x1.5 mm)
[4 Pieces]
#31. Arc Washer (d8xφ20x2xR30 mm)
[2 Pieces]
55
Make sure this wire is hanging out before
assembling the Center post (#28).
40
1 2 3 4
55
40
1 2 3 4
Page 7