Tabla de contenido
Publicidad
RING PLATE ANCHOR
Model #: 7493B1
Date of Mfg: 16.03.15
Material: Alloy Steel
Capacity: 310 lbs Including Tools, Clothing, etc.
OSHA: 1926.502
Serial #: 12345678
Use: Install on top of sheathing into truss or rafter. Use three specified
1/4" x 2‐/2" lag screws ONLY. Pre‐drill 3/16" pilot hole. See manual for complete installation procedures.
WARNING: MANUFACTURERS INSTRUCTIONS, LABELS AND WARNINGS, supplied with the anchor at the time of shipment MUST BE READ
AND FOLLOWED BEFORE USING. Failure to do so could result in serious injury or death. Contact the manufacturer if instructions, labels, or
warnings are missing. THIS ANCHOR MUST BE INSPECTED BEFORE EACH USE. DO NOT USE if anchor has any signs of cracks, corrosion, dents,
deformities, or bending. If the anchor is found to be damaged or it has been subjected to fall arrest forces, remove from service
immediately. Use only with other design compatible components of a comprehensive Personal Fall Arrest System. Anchor point must
support a minimum of 5000 lbs. Anchor must be properly installed to support required load. Take action to avoid chemical, thermal, and
electrical hazard. Avoid contact with sharp and abrasive surfaces. See instruction manual for complete installation procedures. DO NOT
REMOVE LABEL.
MARK ON DATE GRID:
‐Initial in‐service date
‐Date of passed inspection
‐Inspect before each use.
‐Competent person to inspect every 6
months.
Maintain critical edge distance. Ensure the
anchor remains free of interference. See
instruction manual for installation and
proper use procedures.
DO NOT REMOVE LABEL.
J
F
2015
2016
2017
2018
2019
M
A
M
J
J
5
A
S
O
N
D
Publicidad
Tabla de contenido
