Heath Zenith 5311 Manual Del Usuario página 3

Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
1. Remove the existing light fixture.
2. The S-hook can be used to hold the fixture while
wiring. The small end of the hook can be inserted
into a hole in the junction box. The large end goes
around the "neck" of the fixture.
3. Route the light control's wires through the large
hole in the gasket.
4. Twist the junction box wires and fixture wires together
as shown. Secure with a wire connector.
Black to Black
Cover Plate
Gasket
White to White
Junction box ground wire to
green ground wire on fixture.
Mount the Light Control
1. Align the light control cover plate and cover plate
gasket and the junction box. Insert and tighten the
mounting screws.
2. If not installed on a weatherproof box or if an adaptor
plate is used, caulk the wall plate and mounting
surface with silicone weather sealant.
+/- 4°
MOUNT HORIZONTALLY
The halogen light must be
mounted horizontally (+/- 4°).
206442-01
Bulb Installation and Replacement
CAUTION: When replacing the bulb, turn power
off and let the fixture cool.
Important: Use a clean glove or cloth when handling
the new bulb. Use isopropyl (rubbing) alcohol to clean
the bulb if it is touched with your bare hands.
NOTE: The bulb is included, but needs to be installed.
The bulb is located behind the glass cover of the
lamp head.
1. Remove glass cover and remove the old bulb by
pushing the bulb towards the right until the left side
of the bulb is clear of the left socket.
2. To install the bulb, place one end of the bulb on the
contact in the right socket. While pushing the bulb
against the right contact, lower the other end of the
bulb onto the contact in the left socket.
3. Spin the bulb to verify it is seated properly.
4. Re-install the glass cover.
For proper operation and safety, the light fixture must
be above the sensor and the sensor head must be
rotated so that the controls are on the bottom.
Bulb
Left
Socket
Contact
2
3
Lamp Head
1
Right
Socket