After Cleaning - Sono Swiss SW Dura T Serie Manual De Istrucciones

6.8 After cleaning

Post-treatment of cleaned items Typically, the cleaned items need to be rinsed and dried after the cleaning process is complete.
The rinsing liquid(s) to be used during the rinsing stage depend(s) both on the cleaning liquid and on the required degree of cleanness
of the parts. In certain cases, it makes sense to use ultrasound operation also for rinsing.
Emptying unit Drain the liquid from the unit as soon as it is so polluted that it does not achieve an adequate cleaning effect any more, or if the unit will
not be used for a longer period of time (certain types of residue and pollution can damage the stainless-steel tank). Use the drain to empty out the cleaning
tank. To facilitate draining, the floor of the ultrasonic tank slopes towards the drain.
Cleaning the ultrasonic tank For information on how to clean the empty ultrasonic tank, refer to chapter 9.1, Maintenance and care
.
7 CLEANING LIQUIDS
When choosing the cleaning agent, it is very important to pay attention to its suitability for ultrasonic baths.
Otherwise, the ultrasonic tank could be damaged or, in the worst case, operating personnel could be injured.
7.1 Restrictions concerning cleaning agents containing solvents
Flammable liquids, such as solvents, must never be used directly in the ultrasonic cleaning tank.
There is a risk of fire and explosion!
Danger
Observe the hazard information in chapter 6.1.
i
Ultrasound increases the evaporation of the liquids and forms very fine mist which can ignite at ignition sources at any time.
54 | EN
SONOS_2019_01_Gebrauchsanleitung_DURA-T-und-S_lay06-P.indd 54 24.04.19 15:52