Installing The Detector In Association With A Daitem Alarm System - DAITEM SH151AX 3 Manual De Instalación

GB
3. Turn the locking ring clockwise so that the identification mark is aligned with the LEDs.
The yellow indication LED flashes for 5 s and then once every 10 s to indicate the detector is
operating normally.
Locking
ring
4. Proceed to chapter 3. Testing the detector.

2.5 Installing the detector in association with a Daitem alarm system

Recognition programming allows the detector to be recognised by the control panel. The control
panel allocates a detector number following the chronological order of programming.
All the radio detector must be recognized and in radio range with the control panel.
IMPORTANT
• To perform recognition programming operations, the control panel must be in installation mode.
If it is not, enter on the control panel keypad:
master code
• There is no need to place the product close to the control panel for recognition programming.
Indeed, it is advisable to move it away from the control panel by at least 2 metres.
• It is possible to record a personalised message vocally identifying the fire detector (see Control
panel installation manual § Detector vocal identification message).
then
installer code
106
Align mark
and LEDs