Tips; Before First Use - Krups XP3200 Manual De Instrucciones

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
English

3. TIPS

n To extract the fullest flavor from your beans, we recommend using
whole coffee beans that have been freshly ground each time espresso
is prepared. Take care to make sure your coffee is ground to the proper
size for espresso. Too fine a grind will result in espresso that is over-
extracted and bitter. Too coarse a grind will result in espresso that is
under-extracted and weak in flavor. The perfect espresso grind will feel
like fine grains that do not clump when pressed together.
n Store your espresso grounds in an airtight container, and in a cool, dry
place to retain the flavor. Grounds should not be kept for long periods
of time as the flavor will be reduced over time.
n Do not fill your filter holder to the brim. Using the measuring spoon
included, use 1 level spoon of grounds per shot of espresso.
n If you do not use the machine for more than 5 consecutive days, rinse
and drain the water tank.
n Before removing the water tank to fill or empty it, always turn the
machine off.
n Always place the unit on a flat, stable, heat-resistant work surface.
n To obtain an espresso at exactly the right temperature, we recommend
that you preheat your cups.
IMPORTANT!
Before using for the first time, after a prolonged period
of inactivity or after descaling, the machine must be
cleaned as described in Section 4: "BEFORE FIRST
USE".
4. BEFORE USING FOR THE FIRST TIME
Before using your espresso machine for the first time, clean all the
accessories in soapy water and dry them.
Rinse them as follows:
n Open the lid (a) and remove the water tank using the handle (fig. 1).
n Fill the tank (b) with cold water and place it firmly on the machine,
making sure it is firmly in place, and close the lid (fig. 2 et 3).
n Insert and turn the filter holder to the right
n Place a container of sufficient volume under the filter holder.
n Turn the appliance on (fig. 4).
n The "On/Off" light stops (g) stops flashing and turns on.
10
(fig 7).