Fluidmaster 400A Guía De Instalación Rápida página 4

STEP 4: INSTALL NEW FILL VALVE
A: PUSH REFILL TUBE ONTO FILL
VALVE REFILL PORT
B: ATTACH REFILL CLIP TO OTHER
END OF REFILL TUBE
C: INSERT FILL VALVE
Position refill tube to face flush valve
making sure fill valve parts do not
interfere with lever arm.
Fill Valve Refill Tube
Overflow
Pipe
Lever Arm
D: ATTACH REFILL CLIP TO
OVERFLOW PIPE
Note: If refill tube is too long to
fit inside tank with lid closed,
remove refill tube from fill valve
refill port, cut tube, and
reattach to port.
E: INSTALL LOCKNUT
Screw locknut to the right
(counterclockwise) onto fill valve shank
(below tank).
*Hand-tighten only. DO NOT OVER TIGHTEN.
* Over tightening may crack the fill valve or tank causing flooding. Make sure the float cup
does not touch the tank walls or tank lever and flush valve.
6
TOP
DOWN
VIEW
Scissors
(Optional)
RIGHT
STEP 5: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right
(counterclockwise)
*Hand-tighten only.
DO NOT OVER TIGHTEN.
B: TURN ON WATER
Check for leaks.
(Go to www.Fluidmaster.com/support
for leak solutions.)
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½ inch below top of overflow pipe to ensure a
proper flush. (Does not need to be exact.)
**Lever Hole
Over tightening may crack the fill valve or tank causing flooding. Make sure the float cup
*
does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
RIGHT
TURN
COUNTER-
CLOCKWISE
Top of
Overflow Pipe
1/2"
Water Level
Overflow Pipe
7