Hunter Sona Manual Del Propietário página 15

Existing Construction – accessible only from below
D11
EXISTING FAN
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new motor
housing (9"x 9.75").
D13
Route wires through strain relieif. For supply connection, use
wires suitable for at least 90º C (194º F).
D15
F
Screw pre-loaded screws into joist or framing.
D12
Move the housing into position above the ceiling.
D14
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
15
41951-01 12/01/2013
F