Hamilton Beach Stack & Snap Manual Del Usuario página 6

How to Use Chopping/Mixing
Blade or Dough Blade
w WARNING Laceration Hazard.
• Handle blade carefully; it is very sharp. Make sure unit is
switched to OFF ( ) and is unplugged.
• Always use food pusher to feed food into the chute. Never push
food through chute with hands or other objects.
1. Place bowl on base with handle
facing to the right. Carefully place
chopping/mixing blade or dough
blade straight down onto motor shaft.
If desired, add bowl scraper when
using chopping/mixing blade.
2. Add food to bowl. Place lid on bowl,
raise locking arm up and over, and
snap in place. Plug into outlet.
3. Select High (HI) speed by moving the
left switch up, or select Low (LO)
speed by moving left switch down.
NOTE: This food processor will start
in the speed it was last used.
6
4. Move ON ( ) switch up to turn on
food processor or press switch
down to PULSE for instant on and
off control.
5. Turn bowl scraper handle on top of
lid back and forth to remove food
from sides of bowl. Bowl scraper
can be used when unit is running
or when it is OFF.
6. When finished, switch to OFF ( ) and unplug. Push locking
arm back to unlock lid and lower arm onto counter.
7. Always remove lid before removing bowl to avoid possible
damage to the appliance. Remove bowl scraper, if used.
NOTES:
• Operate using only one blade or disc at a time.
• High speed is recommended for most recipes using the
chopping/mixing blade or dough blade.
• Do not use bowl scraper with dough blade.
• Make sure food pusher is in place while operating.