Setting The Air Volume; Length Measurement, Blower And Drive Counter - Leister Varimat V2 Instrucciones De Funcionamiento

1. Work mode

1.5 Setting the air volume

• The air volume can be changed with the Blower button
be set in 5% increments from 50% to 100% by turning the e-Drive
is accepted after 3 seconds, as long as no button is pressed within these 3
seconds. If the air volume is set to 100%, no information will appear on the dis-
play (5).
• The air volume is automatically reduced at a set welding temperature of 500°C and
higher. The air volume can be increased manually by turning the e-Drive
star appears after the air volume display
ensured.
• If this menu is called up from the Setpoint display, heating and blower can be started by pressing
the e-Drive
• The cool down menu can be selected by pressing the e-Drive
• You can change to the relevant menu using the Drive button

1.6 Length measurement, blower and drive counter

• This menu (Fig. 4) appears if the Drive button
• The menu displays all operating times and the distance which the device has travelled
since being switched on. The total distance (here: 1034 m) cannot be changed and
shows the entire path taken since starting up.
• The daily distance (here: 012 m) is not reset automatically, but instead must be
annulled by the user via «Reset» by pressing the e-Drive
• The Time values concern the operating time for the individual components of the
device. The time is assigned to the blower «Blow» (here: 043:58) and the drive «Drive»
(here: 020:10). The «Total» time refers to the operating time. It counts the hours and minutes (here: 143:12)
during which the main switch (3) is switched on.
• If the Back arrow is selected by pressing the e-Drive
from which the Drive button
28
.
has been pressed.
. The air volume can
. The setting
, achievement of the welding temperature is no longer
(section 1.8, Cooling down).
or Heating button
is pressed for at least 3 seconds.
.
, you will be taken back
. If a
.
(Fig. 6)
to the menu