Selecting Profiles; Cooling Down - Leister Varimat V2 Instrucciones De Funcionamiento

1. Work mode

1.7 Selecting profiles

• If the display
be loaded by pressing the e-Drive
A profile can be selected by turning the e-Drive
and 3 can be defined by the user him/herself (chapter 2, Profile setup). All other profi-
les have permanently assigned values and cannot be defined by the user.
• Turning the e-Drive
plays (5) at the bottom. Right arrow
e-Drive to the next page. Left arrow
e-Drive to the previous page.
• If the Back arrow
, you will be taken back to the menu by pressing the e-Drive
from which the Profile menu has been selected.
Perform a test welding according to the welding instructions of the material manufacturer and the
national standards or guidelines. Approve the test welding.

1.8 Cooling down

• If the symbol
OK ?» will appear. Pressing the e-Drive
the display (5), thereby initiating the cooling down process.
• During the cooling down process, the air volume is increased to
100% and the instantaneous welding temperature displayed.
If the welding temperature of 60 °C is fallen below, the blower will continue to operate
for 2 minutes and will automatically switch off after this time
expires. The display changes to the Setpoint display.
• After pressing the e-Drive
values for blower and heating.
• If the Cool down is active, the drive can be switched on/off
manually via the Drive button
The Heating button
function.
at the bottom right of the display (5) is activated, profiles can
. The display «Select Profile» then appears.
activates left or right arrows on the dis-
is activated by turning the e-Drive
is selected by pressing the e-Drive
actives the symbol OK at the bottom right of
the display (5) shows the last set
.
and Blower button
. The profiles Free Adj. 1, 2
by pressing the
by pressing the
,
, the menu «Cool down
do not have any
29