3.6.4 - SETTING THE LEVEL "SOFT-START" AND "SOFT-STOP"
Press the button
: the current setting will appear on the level LEDs.
01.
RDC
Use the
or
button to turn on the LED that corresponds to the desired
02.
setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of
Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected.
2
3
4
5
6
7
8
3.6.5 - SETTING THE LEVEL OF SENSITIVITY TO OBSTACLE / DRC
Press the button
: the current setting will appear on the level LEDs.
01.
RDC
Use the
or
button to turn on the LED that corresponds to the desired
02.
setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of
Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected.
2
3
4
5
6
7
8
Rpm acceleration/deceleration
0.0
0.7
1.5
2.0
2.5
3.0
3.5
4.0
Level
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
LEVEL 5
LEVEL 6
LEVEL 7
LEVEL 8
3.7 - Climatic sensors
3.7.1 - SETTING THE INTERVENTION LEVEL FOR "WIND" PROTECTION
Press the button
: the current setting will appear on the level LEDs.
ON
01.
If no "wind" protection, has been set, the level LEDs flash simultaneously.
Use the
or
button to turn on the LED that corresponds to the desired
02.
setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: The number of levels available depends on the type of motor connected and the
maximum and minimum values of this motor.
3.7.2 - ENABLING/DISABLING OF CLIMATIC SENSORS
This button allows you to enable/disable the intervention of the SUN and RAIN sensors.
If the function is active, the corresponding LED will be lit, otherwise off.
Press the button
to activate/deactivate the SUN and RAIN sensors: the cor-
ON
01.
responding LED starts flashing.
02.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
3.7.3 - SETTING THE INTERVENTION LEVEL FOR "SUN" PROTECTION
Press the button
: the current setting will appear on the level LEDs.
ON
01.
If no "sun" protection, has been set, the level LEDs flash simultaneously.
Use the
or
button to turn on the LED that corresponds to the desired
02.
setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of levels available depends on the type of motor connected and the
maximum and minimum values of this motor.
3.7.4 - SETTING THE DIRECTION OF ROTATION OF THE MOTOR IN CASE OF RAIN
Press the button
to invert the direction of rotation of the motor in case of rain.
01.
02.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
English – 8