Warnings - POLTI VAPORETTO FOCUS M0S10697 Manual Del Usuario

To remove the cloth from the brush, detach
the power supply plug from the electric
socket and wait 5 minutes to allow the cloth
to cool.

WARNINGS

• On surfaces that have been treated with wax,
the wax may be removed by the heat and
steam action.
• Do not use on unsealed wood floors or let unit
stand on any wood floor for an extended pe-
riod of time. This could cause the wood grain
to rise.
• Use extra caution when using on vinyl, lino-
leum or any other heat-sensitive floors.
• Too much heat can melt down glue in the floo-
ring. It is therefore recommended that a sam-
ple cleansing be carried out on an isolated
area of the floor. It is also recommended that
you check the use and care instructions of the
surface from the floor manufacturer to ensure
suitability to steam cleaning.
"WATER OUT"
When the water inside the tank (6) runs out,
steam will stop being produced and a considera-
ble increase in noise will be heard. In any case,
the water level is always visible due to the tran-
sparent tank.
To restart operations just fill the water tank (6)
again as described in the paragraph "PREPA-
RATION".
This operation must always be done by
disconnecting the appliance from the power
source.
ANTICALC FIL TER
By nature, water contains mineral salts that fa-
vour the formation of limescale.
Vaporetto Focus is supplied with a anticalc filter
(7) which reduces the passage of mineral salts
and therefore the formation of limescale.
VAPORETTO FOCUS
When using distilled water, we recommend
that the filter be changed twice per year.
When using normal tap water, we recom-
mend that the filter be changed after every 30
complete water refills.
Filters are available on the www.polti.com site.
To replace the filter, proceed as follows:
• Unplug from the power source.
filter slight force must be exerted.
After use, proceed as follows before putting the
appliance away:
- unplug from the the power supply.
- completely empty the water tank (6) to avoid
water leaks
10
•Remove the water tank (6)
(Fig. 3) pulling it upward.
•Remove the filter (7) still
pulling it upward.
•Position the new filter (7),
applying
checking that it is perfectly
inserted.
To remove and insert the anticalc
•Reposition the water tank
(6).
STORAGE
OF THE APPLIANCE
pressure and