ASSEMBLY INSTRUCTIONS
5. Secure the suspension bracket I (C) to fan housing using screw
(CC) (included). Secure suspension brackets (D & E) with
screws (BB) (included).
6. Remove junction box cover. As shown in wiring diagram on
page 5, using quick connect ports connect house wires to
switch and fan.
Note: Do not use metal wall plate with the switch, as it may
cause interference with the fan operation.
ATTENTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not
present, one will have to be ran by a qualified professional.
Please see the Wiring Diagram on page 5 of your instruction
manual. If you require assistance, please call 1-877-319-3757
before attempting this switch installation.
NOTE: This switch is intended to only operate independently
with this bath fan, connections to other electrical fixtures should
be avoided.
7. Connect a 4 in. circular duct and vent to theoutside. Secure it
with duct tape or clamp.
Turn on power source.
EXISTING CONSTRUCTION – ACCESSIBLE
FROM ABOVE
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Remove existing fan.
www.homewerksww.com
5
6
7
1
7
Wall
Green
Wall switch
switch
wire
back view
NIGHT LIGHT
Red
wire
White
wire
Black
wire