Bluetooth ® Speaker Fan Grille Installation - HomeNetWerks 7130-06-BT Manual Del Usuario

ASSEMBLY INSTRUCTIONS
7. Secure the suspension bracket I (C) to fan housing using
screw (CC) (included). Secure suspension brackets (D & E)
with screws (BB) (included).
8. Remove junction box cover. As shown in wiring diagram on page
5, using quick connect ports connect house wires to switch and
fan.
Note: Do not use metal wall plate with the switch, as it may
cause interference with the fan operation.
ATTENTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not present,
one will have to be ran by a qualified professional.
Please see the Wiring Diagram on page 5 of your instruction
manual. If you require assistance, please call 1-877-319-3757
before attempting this switch installation.
NOTE: This switch is intended to only operate independently
with this bath fan, connections to other electrical fixtures should
be avoided.
9. Connect a 4 in. circular duct and vent to the outside. Secure it
with duct tape or clamp (not supplied).
Turn on power source. Test the fan.
BLUETOOTH SPEAKER FAN GRILLE INSTALLATION
®
Housing must be installed flush with ceiling board or the grille mounting spring will not be long
enough to insert into the slots inside the fan housing.
1. Join the connectors for the BLUETOOTH
wires), light (white wires), and RF receiver (gray wires).
www.homewerksww.com
speaker (black
®
9
7
8
9
1
Wall
Green
Wall switch
wire
switch back view
NIGHT LIGHT
Red
wire
White
wire
Black
wire