Use; Control Panel - ROBLIN CREATIX Manual Del Usuario

USE

A B
Button Function
A Turns the Motor off.
Enables / Disables Keyboard Lock mode if pressed and
held for 5 seconds.
B Activates speed one.
C Activates speed two.
D Activates speed three.
E Activates Intensive speed. This speed is timed to run
for 6 minutes. At the end of this time the system will
automatically return to the speed set before.
It is disabled by pressing the Button or turning the Mo-
tor off.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 5
seconds.
F Starts the 24H function, in which the motor starts at a
speed that allows suction of 100 m
hour. This mode cannot be activated if Intensive or
Delay modes are active.
To turn it off, press the button again.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for approxi-
mately 5 seconds. These indications are only visible
when the motor is turned off.
G Activates Delay mode, with automatic shutdown of the
Motor, the Fans and the Lighting with a 30' delay.
It is disabled by pressing the button or turning the motor
off.
Pressing and holding the button for 5 seconds enables
the remote control
Pressing and holding the button for 5 seconds disables
the remote control
H Press briefly to turn the lighting system on and off at
maximum intensity.
Press and hold the button for 2 seconds to turn the
Courtesy Lights On (if provided).
EN
C D

Control panel

3
/h for 10 minutes per
E F
Led
The Leds indicating the Speed of the motor turn off.
All the Leds light up in cycle.
The Leds indicating Speed one and Motor Off turn on.
The Leds indicating Speed two and Motor Off turn on.
The Leds indicating Speed three and Motor Off turn on.
Flashes once a second.
Button A Led flashes twice.
Button A Led flashes once.
The Leds indicating 24H speed and Motor Off turn on.
When the procedure terminates, the indication shown
previously turns off:
24H Flashing
Indicates the need to wash the metal grease filters. The
alarm is triggered after the Hood has been in operation
for 100 working hours.
24H Flashing
Indicates the need to change the activated charcoal fil-
ters, and also to wash the metal grease filters. The alarm
is triggered after the Hood has been in operation for 200
working hours.
The Delay Led lights up.
Button A Led flashes twice.
Button A Led flashes once.
The Lighting Led lights up.
G H
2
25