Cobra GLOBE 4800/4900 CAN Manual De Instalación página 16

To increase the volume make the same sequence keeping pressed the button quickly for few times.
The volume of the buzzer will increase at each pression.
Turn the ignition key OFF then ON to go to the next table. The turn indicators will flash twice to
indicate that you are in the basic functions table. This signal is repeated every 10 s to indicate which
table you are in.
Turn again the ignition key OFF and then ON to go to the advanced functions table. The system will
confirm the new table with 3 turn indicator flashes.
ACTIVATE/DEACTIVATE A FUNCTION
After entering in the base functions or advanced functions tables, press briefly the button on the
control panel and position on the number of the line corresponding to the function that you wish to
activate/deactivate. The quick flashing will indicate that the function is deactivated, the slow flashing
will indicate that the function is activated. The number of flashing corresponds to the number of the
line of the functions table that you have selected.
Keep pressed the button of the control panel to activate/deactivate a function until the frequency of
the flashing LED changes.
More functions can be activated at the same time on the same page.
The activation of a function does not automatically deactivate the others.
When closing the bonnet, the system signals with a flash of 3 s of the turn indicators that you are
leaving the programming procedure. Refer to the programming tables for functions.
CAN BUS CONFIGURATION
The products CAN BUS 4800/4900 are factory-programmed to support different vehicle platforms
with a serial CAN (Controller Area Network) interface.
This procedure is crucial to fix within the product the correct vehicle platform chosen from a list of
available vehicles present within the system (see index table CAN).
Programming mode is entered only during the first 5 s each time the system is powered.
The entry into "Programming Functions" and the activation of a function, disables the
possibility to reconfigure the product.
During the first 5 s, signalled by the fast flashing of the LED, press for 1 s the button of the control
panel. The LED will flash to indicate the entry in the vehicle index, a number of times programmed
from manufacture (e.g. 3 flashes).
The number of flashes corresponds to the line number of the index table CAN. Each line of the
index table corresponds to a different vehicle platform.
Press briefly the button of the control panel, each time the button is pressed the index is increased,
when the maximum number of codes available has been reached the count will loop round to
number one.
Position yourself to the number of flashes of the LED corresponding to the vehicle platform desired,
wait approximately 20s for confirmation programming mode has been closed, signalled by the led
switching off.
Switch off and then on the systems power supply and wait until the sequence of fast flashes, for
confirmation it has been correctly configured.
Check the functionality of the pre-selected configuration pressing the button of the original remote
control, the system will set it self.
GB
16
06DE2178A SEGN.pmd 16
FITTING INSTRUCTIONS GLOBE 4800/4900 CAN
POUR ACCEDER LA PROGRAMMATION
ALARME
A
B
DESACTIVEE
ON
OFF
D E
IGN + 15
POUR CHANGER DE TABLEAU
OFF ON
POUR ACTIVER/DESACTIVER
UNE FONCTION
MIN 2 s
GLOBE 4800/4900 CAN MANUEL D'INSTALLATION
17/11/2005, 14.38
C
PIN code
F
OK
POUR CHANGER DE LIGNE
MAX 1 s
POUR QUITTER
F
25