Springlane Mila Manual De Instrucciones página 27

forming in the mixing chamber.
If foam residues remain after the
end of the programme, flush out
the appliance using the 3-minute
flushing programme. After the
end of the self-cleaning process,
open the lid to allow the mixing
chamber to dry.
3. Open the lid and simply remove it
in the vertical direction for easier
cleaning by hand. You can also simply
remove the plug. Do not clean the
lid and plug in a dishwasher, to avoid
damaging the seals.
4. Also regularly clean the metal pins pro-
truding into the mixing chamber, the
silicone valve through which the water
flows into the mixing chamber, as well
as the silicone spout with a damp cloth.
5. Regularly clean the water container to
make sure it always stays hygienically
clean.
6. Clean the housing with a damp and soft
cloth and thoroughly dry afterwards.
Tip: should the blades be stained by
ingredients, pour some water into the
mixing chamber and add a denture
cleaning tablet. Leave it to stand for 1–24
hours before running a short manual
cleaning programme.
Warning: If you wish to
clean the blades by hand,
switch off the device and remove
the mains plug. Please pay attenti-
on and be careful, the blades are
very sharp.
Do not disconnect the
power supply of the appli-
ance during the cleaning program-
me and do not interrupt the
programme.
Remove residues from the mixing
chamber
Please follow these steps if you wish to
remove any residues or unfinished milk
left in the mixing chamber due to a power
outage or for a different reason:
1. Connect Mila to the power supply.
2. As soon as the display shows all sym-
bols, you can have the rests fed out by
holding the "Capacity" button.
3. Afterwards, start a manual cleaning
programme using the "Cleaning"
button.
Descaling
Treat Mila with care and only use filtered
water. You should additionally descale
27