CyberPower Professional Rack Mount LCD Series Manual De Usuario página 3

INSTALLING YOUR UPS SYSTEM
UNPACKING
The box should contain the following:
®
(1) UPS unit x 1; (2) User manual x 1; (3) Phone line x 1; (4) PowerPanel Business Edition software CD x 1; (5)
USB A+B type cable x 1; (6) Rack mount Brackets x 2; (7) Emergency Power Off Cable (gray) x 1; (8) Serial
Interface Cable (DB-9) x 1; (9) Power cord x 4 (Power cord x 6 for PR2200ELCDRT2U)
AUTOMATIC VOLTAGE REGULATOR(AVR)
The PR1000ELCDRT2U/PR1500ELCDRT2U/PR2200ELCDRT2U can stabiliz
the consistent utility power. The utility power may be damaging to important data
and hardware, but Automatic Voltage Regulation helps the computer not
experience dangerous voltage levels. Automatic Voltage Regulator automatically
regulates low or high voltages to keep equipment working at safe AC power levels
(220/230/240V) without switching to battery. Your equipment can operate normally
even meet the power problems, such as, shout brownouts and blackouts. The
unit's powerful sealed lead-acid batteries will provide power only if the incoming
voltage drops below 150V or increases above 300V.
INSTALLING YOUR UPS SYSTEM (continued)
SYSTEM BLOCK DIAGRAM
HARDWARE INSTALLATION GUIDE
1. Battery charge loss may occur during shipping and storage. For the first time the UPS is used, it's strongly
recommended to charge batteries for at least 12 hours is recommended to ensure that the batteries' maximum
charge capacity. To recharge the batteries, simply make the UPS plugs into an AC outlet.
2. When you use the included software, connect either the serial or the USB cable between the computer and
the corresponding port on the UPS. Note: If the USB port is used, the serial port will be disabled. They cannot
®
be used simultaneously. The computer with the PowerPanel Business Edition S/W connects to the USB port
or the Serial port on the UPS. It can control the operating schedule, battery test, outlet, etc. and get information
®
on the UPS status. However, other computers with PowerPanel Business Edition S/W can only get UPS
status information via a LAN connection.
3. With the UPS off and unplugged, connect your computer, monitor, and any externally powered data storage
device (Hard drive, Tape drive, etc.) into the outlets. DO NOT plug a laser printer, copier, space heater,
vacuum, paper shredder or other large electrical device into the UPS. The power demands of these devices will
overload and possibly damage the unit.
Copyright © 2015 CyberPower Systems, Inc. 2