Error
Appliance cannot be started
Insufficient water quantity
Insufficient vacuum perfor-
mance
Insufficient cleaning result
Detergent dose gets reduced
The detergent bottle gets de-
formed when detergent is suk-
ked out of it. There is no air
coming in to equalise the
pressure.
Brushes do not turn
Drain hose for dirtyy water is
blocked
20
English
Faults
Remedy
Check batteries, charge if required. Fully charge battery
if it has got discharges so that the electronics system can
release the function lock.
Check battery pole fuse at the positive pole of the battery
(100 A); inform customer service if the fuse is defective.
Check fresh water level, refill tank if necessary.
Check hoses for blockages; clean if required.
Saber Compact 22 SP: Remove the cover of the water
supply at the suction head and clean the water canal.
Clean the seals between dirty water reservoir and cover
and check for tightness, replace if required.
Clean the lint filter.
Clean the squeegee blades on the squeegee tool, turn or
replace if required
Check if the vacuum hose and squeegee tool are chok-
ked, clean if required
Check the vacuum hose for tightness; replace if required.
Check if the cover on the dirty water discharge hose is
closed
Check the setting of the squeegee tool.
Check whether the turbine is running and is creating un-
der-pressure; call Customer Service, if required.
Drive in the running gear.
Check the brushes for wear, replace if required.
Check detergent metering (optional).
Replace pump hose of the metering pump.
Tilt out the detergent intake and take out the detergent
bottle.
Close the lid of the detergent bottle.
Pull out the valve (rubber cap) and clean it in warm water.
Replace the valve.
Check if foreign matters block the brushes; remove for-
eign matter if required.
Open metering equipment at the drain hose. Pull out the
vacuum hose from suction beam and close it by hand.
Set the program selection switch to suction or vacu-
uming. The blockage will be sucked out from the drain
hose into the dirty water tank.