Cleaning And Maintenance - Domo DO908DV/02 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
·
SN: Subnormal: ambient temperature between 10°C and 32°C
·
N: Normal: ambient temperature between 16°C and 32°C
·
ST: Subtropical: ambient temperature between 16°C and 38°C
·
T: Tropical: ambient temperature between 16°C and 43°C
DOOR CONVERSION
The freezer is built with the door hinges on the right side. If you want to switch the direction in which the
door opens, follow the following instructions:
1.
Remove the cover of the upper hinge (6).
2.
Remove the 3 screws (1) that attach the upper hinge (5) to the freezer. Remove the upper hinge.
3.
Lift the door and place it on a soft surface so that it does not get damaged.
4.
Remove the 3 screws (8) that attach the lower hinge (2) to the freezer. Remove the lower hinge.
5.
Remove the left front leg (4) and move it to the right side of the freezer.
6.
Replace the cover plate (7) to the right side.
7.
Before placing the lower hinge (2), remove the bolt (the right leg) (9) en reverse the direction of the
lower hinge. Install the lower hinge at the bottom left of the freezer with the 3 screws (8).
8.
Screw the bolt (9) back into the lower hinge (2).
9.
Place the door in its place, on the lower hinge (2).
10. Close the door and hold it in position while you attach the upper hinge (5) to the upper left corner of
the freezer with the 2 screws (1). Make sure that the door is straight before fastening the screws.
11.
Place the cover (6) onto the upper hinge.
USE

CLEANING AND MAINTENANCE

MOVING YOUR APPLIANCE
·
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will
allow the refrigeration system pressures to equalise before restarting.
·
Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the freezer to avoid any shock.
·
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes.
·
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation
to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the
room where the appliance is located for a few minutes.
30
DO908DV/02

Publicidad

Tabla de contenido
loading

Tabla de contenido