Assembly - Klarfit Highflyer FX2 Manual De Instrucciones

EN
26

ASSEMBLY

Note: Only tighten the screws slightly during initial assembly. Tighten them
fully only after completion of installation.
Console columns
Lift one part of the console column and bracket
using one M8 * 45 screw on each side of the
1
treadmill. Slide the screws through the lower
connection hole, add the washers and tighten the
screws. Tighten the two console columns with
two M8 * 20 screws.
Console and handle
Attach the handles on both sides with a M8 * 20
2
screw by passing them through the handle hole
and connecting them to the console columns.
For multifunction devices with front massage module:
U-shaped tube (top and bottom)
First attach the rubber protective sleeve to each
side of the U-shaped tube. Then attach the 2
ends of the U-shaped tube to the metal plates
of the left and right tripod columns with M8 *
3
40 screws. Then secure the screws with nuts.
The central screw hole of the U-shaped tube is
obliquely aligned. The lower U-tube is equipped
with foam, the upper without foam (see picture
on the right).