Installation; Setting Up Light Source - Sunoptic Surgical SolarMaxx 180 Manual De Uso

7 Hour meter reset
button
8 Connector

5. INSTALLATION

5.1 SETTING UP THE LIGHT SOURCE
Place the light source on a stable surface (cart, counter, stand, etc.).
NOTE Avoid places where the light source may be splashed with liquid.
Absolutely DO NOT use in any environment with explosive or flammable
gases.
DO NOT block the venting grids of the light source or impede exhaust air
flow. Users must ensure that ventilation air temperatures are below the
maximum rating for the light source and are not influenced by warm
exhaust from other sources.
Make sure the power switch is in OFF position.
Connect AC power cord to the power inlet located on the rear panel of the light source.
Make sure power cord is completely seated into the power inlet.
CAUTION
Plug the AC power cord into a wall outlet using the three (3) prong plug supplied with the unit.
CAUTION
NOTE When using medical isolation transformer, be sure to check the
transformer power ratings.
with
transformers and/or power strips only).
LIT034 Sunoptics Surgical
(English)
Resets hour meter to zero hours
For potential equalization
Use only cords provided with the light source.
To prevent electric shock, connect power cords of peripheral
equipment through medical isolation transformers.
Make sure that the power cord is connected to the main power
three prong
®
plug (USA use
1 2
3 4
UL2601-1 rated
Rev. N
Date of Revision:07/02/14
Page 9 of 68
isolation