LIVARNO LUX LLES B2
Cleaning / maintenance
Maintenance
The energy-saving outdoor spotlight does not contain any parts that require maintenance.
Replacing the light bulb
The circuit must be disconnected during all work on the energy-saving outdoor spotlight, even
when changing the light bulb! There is a risk of an electric shock!
Only use energy-saving spiral light bulbs with E27 base and a maximum power of 23 watts!
Loosen the 2 screws (1) with a Phillips screwdriver and carefully tilt the front pane (9) downwards.
Unscrew the old/defective energy-saving light bulb (10) anti-clockwise out of the socket. Then screw a
new energy-saving light bulb of the same design (see "Technical data" section) clockwise into the socket.
When doing so, handle the energy-saving light bulb (10) by its base and not by its glass body. The bulb
should only ever be handled with a cloth. Close the front pane (9) upwards now and tighten the 2 screws
(1) again.
Switch on the circuit again.
Cleaning
The circuit must be disconnected during all work on the energy-saving outdoor spotlight, even
when cleaning it! There is a risk of an electric shock!
Ensure that no liquid can penetrate the housing of the energy-saving outdoor spotlight. There is
a risk of an electric shock.
To clean the energy-saving outdoor spotlight, use a soft, dry cloth and never use any solvent or cleaner
that would corrode the plastic materials. Use a slightly damp cloth for more stubborn dirt.
Troubleshooting
The light does not switch itself on
The motion sensor (8) is not aligned correctly. Correct the alignment.
The energy-saving light bulb (10) is faulty. Replace it.
The electrical connection is faulty. Get an authorised electrician to check the electrical connection.
The light switches on and off quickly
The sensor is disturbed by extraneous light or bright reflective surfaces. Remove the extraneous light
source or the disturbing surfaces.
46 - English