Caster Assembly; Wet/Dry Vac Assembly - Workshop WS0500VA0 El Manual Del Propietario

SP6881-1 Workshop:SP6439-3_ES.qxd 8/26/13 11:25 AM Page 6
With the power head and lid assembly
removed from the drum, and the drum
upside down on the floor:
1. Insert the caster stem into the socket
of the drum, as shown (4 places).
2. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
3. Turn the drum upright.
1. Line up front of power head assembly
with vacuum port located on the front
of the drum, as shown.
2. Place power head assembly on top of
drum.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Push down on top of the drum latch
areas to cause the flexible locking tabs
to hook onto the drum channel.
5. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off. (See inset).

CASTER ASSEMBLY

WET/DRY VAC ASSEMBLY

Caster
Stem
Caster
Ball
Socket
Dust
Drum
Out
Flexible
Locking Tab
Top
Assembly
Push
Down
Pull Out
Flexible
Locking
Tab
Drum
Channel
6
Drum
Push
Down