Preparing Your I-Neb - Philips Respironics I-neb AAD Guia Del Usuario

3.4 Preparing your I-neb
Before you take your first treatment, there are
four things you will need to do:
1. charge the battery,
2. insert the prescribed dosing disc,
3. wash the mouthpiece, medication chamber
and drug guide,
4. and get used to assembling the I-neb.
Before you take your first treatment,
1
charge the battery for 3-6 hours or until
you see the fully charged symbol (below).
To charge the internal battery, clip the
2
I-neb onto the battery charger and connect
the plug to an electrical outlet. When
the I-neb is fully charged unplug it from
the outlet. Unclip the battery charger
by pressing the grey buttons on the side
of the charger unit. Always charge your
battery when it reaches two bars on the
battery indicator. When there is only one
bar appearing on the battery indicator, you
can continue to use I-neb with the battery
charger attached.
Caution
Do not leave the battery charger plugged into
the electrical outlet after charging.
6
12035_RRDD_InebPH_InstESUS_1056844_Issue1_v10.indd 8
Insert the prescribed dosing disc: When
3
you start your therapy, your healthcare
provider will tell you which dose and
disc to use. Please refer to the chamber
information guide (section 7.1). Always
use the dosing disc prescribed by your
healthcare provider. If you lose your disc,
or if you have any questions about which
disc to use, please call patient support.
The disc is supplied on a card. Your
4
healthcare provider will tell you which disc
to use. Remove the disc from the card.
Keep the card for future reference. Slide
the disc fully into the slot at the front of
the I-neb. It does not matter which way the
disc is inserted.
Caution
• Leave the disc in place on the I-neb in
between treatments.
• If you do not insert a disc, I-neb will not
work.
Before you start
18/02/2010 12:23