Assembly - Truper CAZ-EL-7B Manual Del Usuario

Assembly

C
B
F
D
J
Disc Installation
1. Remove the water reservoir pan.
2. Disassemble the fixed guard (A) loosening the two screws
using a Philips-head screwdriver.
3. Set the inner washer (B) in the motor axis (C).
4. Next, set the disc in the axis. so that the arrows marked in
the axis' sides match the arrows in the axis' sides. Double
G
check the disc is inserted in the felt devices (D) to control
excessive water when cutting.
5. Set the outer washer (E) and then, the nut (F).
6. Tighten the nut in a clockwise direction with the hex key
(G), while keeping the axis fixed with the special wrench (H).
7. To remove the disc, reverse the steps.
CAUTION
disc manually to assure it has no obstructions.
CAUTION
the machine.
E
H
A
Fill the Water Reservoir Pan
• To prevent the cutting disc gets overheated and a
deficient functioning of the machine, always keep the pan
full with water.
• Fill the pan until the water level is between the two
marks of minimum and maximum (I).
WARNING
I
detergent in the water.
CAUTION
• When filling the pan, do not exceed the maximum water
level.
Adjust the Disc Slot
• Remove the disc guard loosening and removing the
fastening knob.
• Loosen the two safety screws (J).
• Adjust the slot so that it is aligned with the disc, that the
distance between the edge and the disc is not higher than
3/16".
• Tighten the safety screws.
• Set back the disc guard.
• Before connecting the machine, turn the
• Replace damaged discs before turning ON
CAUTION
• Use only discs with
the specified characteristics, with no
openings nor slots.
• Do not mix chemical products or
• Never leave the disc working dry.
ENGLISH
7