Operating Elements; Before Commissioning; Operation - Windsor Pivot Manual De Instrucciones

1 Brushing rollers
2 Button for brush change
3 Bearing wheel
4 Strain relief clamp
5 Push handle
6 Switch for detergent solution
7 Switch for brush drive
8 Support of the transport wheel
9 Electrical plug
10 Lock of pushing handle
11 Solution tank cover
12 Solution tank
13 Release button for the transport
wheel

Operating elements

Before Commissioning

Installing the pushing handle
Warning
Risk of damage. Do not pinch the cable
during the installation.
Slide the lock of the push handle up.
Place the lower push handle verti-
cally and lock.
Slide the upper slider half onto the
lower slider half.
Insert the screw into the star handle
and tighten it.
Attach the cable to the wire hook on
the push handle.
Installing the Brushes
The brushes must be installed before
the initial operation (see "Mainte-
nance").

Operation

Note
To take the brush drive out of opera-
tion, immediately release brush drive
switch.
Chemical filling
Warning
Risk of damage. Only use the recom-
mended detergents. With respect to
different detergents the operator bears
the increased risk regarding the opera-
tional safety and danger of accident.
Only use detergents that are free from
solvents, hydrochloric acid and hydrof-
luoric acid.
Note
Do not use highly foaming detergents.
Observe the meter mixing notes.
Open the cover of the fresh water
reservoir.
5
English