Start Up; Rotation Direction - Truper ROTO-1/2N6 Manual De Instrucciones

Start Up

Bit Fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck key and tighten the chuck alternatively into each
of the orifices.
WARNING
• Clean burr and any other foreign
object from the bit and the chuck. Otherwise, the bit
cannot be tight and could cause personal injuries.
Start Up and Operation Control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed Control
• The tool can operate in different speeds. These can be selected adjusting the
speed control (C) built in the switch.
• Turn the speed control in a clockwise direction to increase the Hammer Drill
speed and torque.
• Turn in a counterclockwise direction to decrease speed and torque.
Changing From Hammer Drill To Drill
• To drill concrete, floor tile or materials of similar hardness, move the
impact-rotation selector (D) all the way towards the
will hit the material while rotating at the same time.
• To drill metal, wood or plastic, move the impact-rotation selector completely
towards the DRILL to make the bit rotate onto the material.
WARNING Do not try to drill metal, wood or plastic with the hammer drill
into IMPACT mode setting (selector towards
will lessen and the bit tip gets damaged.

Rotation Direction

• To have the bit rotating forward and drill, press the rotation selector (E), the
button with the arrow pointing the chuck.
• Turn in reverse and habilitate the screwdriver press the button with the arrow
pointing the Hammer Drill handle.
Never use the tool in reverse when having the impact - rotation
WARNING
selector into the IMPACT position (selector towards
system will be severely damaged.
Adjusting Auxiliary Handle And Depth Control Rod
• To set the auxiliary handle into the right position to operate as
hammer drill turn the auxiliary handle as indicated in the figure.
When the auxiliary handle mount is loose, turn it into the desired
position. Turn the auxiliary handle in a reverse direction to fix it in
the new position.
• To move the depth control rod, loosen the frame as explained in
the previous paragraph. Once loose push the rod to the desired
depth. Tighten the auxiliary handle to fix the rod into the new
position.
Bit
IMPACT mark. The bit
). Otherwise the tool efficiency
). Otherwise, the impact
Chuck
C
A
D
Drilling Button Activated
E
Switch
ENGLISH
Chuck
Key
B
7