Troubleshooting - Abicor Binzel ABICUT 155 Instructivo De Servicio

ABICUT 155

10 Troubleshooting

Fault
Insufficient penetration
Cutting arc breaks
Tab. 11 Troubleshooting
2 The electrode must be replaced if the weld penetration is deeper than 1.5
mm.
3 Clean the cutting torch body regularly to remove cutting spatter.
4 Check the spring recoil of the torch contact pins and clean the contact area
of the protection cap and/or replace the torch contacts if necessary.
ABICOR BINZEL offers factory repair services.
DANGER
Risk of injury and machine damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is carried out to it by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
Please observe the attached 'Warranty' document. In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
NOTICE
• Please consult the operating instructions for the welding components,
such as the welding power source and the robot control unit.
Cause
• Pressure drop during cutting
• Cutting rate too high
• Tilt angle of torch too great
• Material thickness too high
• Equipment parts worn or
damaged
• Output not adjusted
• Cutting rate too low
• Torch clearance too great
• Material thickness too high
• Output too low
10 Troubleshooting
Troubleshooting
• Reset pressure monitor
• Reduce cutting rate
• Reduce tilt angle
• Use a lower material thickness
• Replace the equipment parts
• Adjust the output
• Increase the cutting rate
• Reduce the torch clearance
• Use a lower material thickness
• Adjust the output
EN - 17