Descargar Imprimir esta página

Emptying The Dust Container - Grundig VCC 4770 A Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
INFORMATION ___________________________
Switch off and unplug the appliance before
cleaning it.
Warning
Never use gasoline, solvent, abrasive cleaning
agents, metal objects or hard brushes to clean
the appliance.
Emptying the dust container
1
Press the dust container removal button
remove the dust container
dust container in the direction of the arrow by
holding from the dust container carrying handle.
2
Open the lid of the dust container
ing the inner latch and empty the container.
3
When you have emptied the dust, close the dust
container lid
.
D
A click will be heard.
4
Insert the dust container
holding it from the handle.
Cleaning the filters
Warning
Do not use appliances producing hot air such as
hair dryer or heater to dry the filters.
Do not install the filters without completely dry-
ing them; otherwise, smell of moisture may occur
during use, water can leak from the back of the
appliance or the filters may get damaged.
Attach the filters into their places after they have
dried.
22
ENGLISH
to
H
and remove the
D
by press-
D
into its place by
D
Motor protection filter and HEPA filter
These filters are located on the rear side of the dust
container
.
D
1
Press the dust container removal button
remove the dust container
2
Remove the HEPA filter and motor protection
filter found at the back of the dust container
3
After washing the sponge protection filter under
running water, wring it out slightly and leave it to
dry (for 24 hours minimum).
4
Shake off the HEPA inlet filter to eliminate the
dusts on it. After that, you can wash it by holding
its clean side under running cool water.
5
If you wash the HEPA filter, dry it at room tem-
perature (for 24 hours minimum). Do not use it
before ensuring that it is completely dry.
HEPA filter and outlet filter
HEPA outlet filter is located on the rear side of the
appliance.
1
Remove the HEPA filter by pulling it from its han-
dle.
2
Shake off the HEPA outlet filter to eliminate the
dusts on it. After that, you can wash it by holding
its clean side under running cool water.
and
H
.
D
.
D

Publicidad

loading