Beninca ONE.2WI Manual Del Usuario página 12

433,92MHz Radioreceiver 1/2 channels, multiple decoding,
compatible with Advantouch system.
They are available with Molex (ONE.2WI) socket or in a plastic
box with terminal board (ONE.2WB) or in a plastic box for
external use (ONE.2WO). The standard memory can contain
512 rolling-code, 433.92MHz, transmitters maximum A
special version is available with a memory that can hold 2048
transmitters. A full memory is indicated by 10 orange blinks.
N.B: The Advantouch
management software permit the use of certain advanced
functions, please consult the relevant instruction manual for
more information.
IMPORTANT:
The radio receiver ONE.2 is compatible with the new ARC
(Advanced Rolling Code) transmitters which, thanks to 128-bit
encryption ensure superior copy-security.
Storing new ARC transmitters is quite similar to that of normal
rolling code transmitters with HCS coding, but be aware that:
1) ARC transmitters and Rolling Code HCS can not be stored
in a single receiver.
2) The first transmitter memorized determines the type of transmitters
to be used later. If the first transmitter memorized is ARC, you can
not store Rolling code HCS transmitters, and vice versa.
3) Fixed code transmitters may only be used in conjunction with
Rolling code HCS transmitters, bringing the logic (or dip / switch)
CVAR OFF. They are, therefore, not usable in combination with
the ARC transmitters. If the first rolling code transmitter stored
is an ARC CVAR the logic is inoperative.
4) If you want to change the type of transmitters it is necessary
to proceed with a receiver reset (as described in the manual).
12
ENGLISH
palm programmer and
To optimise reception install the antenna away from metal
bodies and avoid positioning several receivers next to each
other. If no antenna is used reception will be considerably
reduced.
Memorising transmitters – Simplified procedure
To merely record one or more transmitters to activate the first
channel, follow this simplified procedure:
1 Press and release the button P on the receiver.
2 The Red LED will light up for 3 secs, then go out for 1 sec and
related
then light up again for 5 secs.
3 While the red LED is on, press the button on the transmitter
to associate with channel 1.
4 Other transmitters can be then be recorded by pressing a
button within 5 secs from recording the previous transmitter.
5 To end wait 5 secs, the receiver will exit programming.
Memorising a transmitter – Remote self-learning
If a transmitter has already been memorised on the receiver the
remote radio self-learning feature can be used (without having
to use the receiver button P). Proceed as follows:
1 Press the hidden button on the memorised transmitter.
2 Press, within 5 secs., the button on the memorised
transmitter corresponding to the channel to associate with
the new transmitter.
3 Press, within 5 secs., the button on the new transmitter to
associate with the channel selected at point 2 above.
4 The receiver will memorise the new transmitter and promptly
exit programming.