Joie stages fx C1719 Manual De Instrucciones página 14

1. Press the red button to disengage
the buckle.
40
2. To remove the crotch pad, first
locate the elastic on the inside of the
crotch pad. Pull both the elastic and
the crotch pad over the buckle to
remove.
42
3. Remove the infant insert.
!
When installing the child restraint in
the booster mode, do not use the
infant insert.
43
1
4
-1
4. Detach the snaps and the hook and loop fastener on the seat pad.
43
5. Lift the upper flap of seat pad upward and pull the lower flap forward. Then
-3
store the shoulder straps and buckle tongues in their storage
43
-4
compartments.
43
6. Pull the buckle through the slot in the seat pad and then store the buckle in
-5
its storage compartment.
43
-1
7. Reattach the snaps and the
43
-2
hook and loop fastener to
43
recover the seat shell.
44
!
To convert back to forward facing
mode from booster mode, please
reverse the above steps.
25
42
2
3
5
-2
43
44
ii. Securing your Child in the Child Restraint
a. For installation with 3-point-belt
1. Place the child in the child restraint
and check whether the shoulder belt
guides are at proper height.
2. Position shoulder belt through
shoulder belt guide, pass waist
belt through lap belt guidings. Fasten
buckle and pull the vehicle belt
to tighten.
45
!
Shoulder belt must pass through
-1
shoulder belt guide.
46
!
Waist belt must pass through
lap belt guidings.
!
The child restraint can not be used
if the vehicle safety belt buckle
(female buckle end) is too long to
anchor the child restraint securely.
-1
45
!
Never use a vehicle waist-only belt
across front of child.
!
Do not use shoulder belt loose or
positioned under arm.
!
Do not use shoulder belt behind
child's back.
!
Do not allow child to slide down in
the child restraint in case of
strangulation.
!
When not in use, Top Tether MUST
be properly stored. To make sure the
top tether is properly stored away,
remove any slack in strap to avoid
the top tether swinging around when
the vehicle is in progress.
38
45
1
46
1
2
26