Aqua Medic Ocean Light Manual De Instrucciones página 10

Stainless steel cable:
Now, the stainless steel cable is fed through the nut (1.3) of the ceiling plate so that the stopper
(1.2) is placed inside the ceiling plate. The nut is screwed onto the ceiling plate allowing the
stainless steel cable to hang free.
Fixing of the lamp:
The stainless steel cable is fed through the lamp fitting of the Y-piece from the top (2.1.1). It
comes out of the lateral opening (2.1.2) and then it has to be pulled out and adjusted to the
correct height above the aquarium. When the lamp is levelled, the locking bolt (2.2) is tightened in
order to prevent an unintentional tilting of the lamp.
Release the fixing:
The lamp includes a non-return mechanism so that the cable can easily be adjusted. If more cable
is needed or the lamp shall be taken down, press the fixing screw (2.1.1) with your finger. - Note:
Hold the lamp tightly. The stainless steel cable can now be removed from the lamp fixing.
When the lamp is mounted in the correct position, any surplus wire may be cut off with pliers.
Pay attention to the required minimum distance of 30 cm to the water surface!
Pict. 2: Steel wire suspension:
1.1 Ceiling suspension
1.2 Stopper at the stainless steel cable
1.3 Nut for ceiling suspension
2.1 Lamp fixing
10
2.2 Safety bolt
2.1.1 Fixing screw for release
2.1.2 End of cable