Assembly; For Juicing; For Pureeing - Rena Ware NUTREX JUICER Uso Y Mantenimiento

Assembly

Caution: Before assembling or disassembling the juicer, make sure it is
switched off and unplugged.

For Juicing

1. Place the juice collector on the motor
base by aligning the three tabs in the
bottom of the juice collector with the
matching recesses on the motor base
(Step 1).
2. Place the stainless steel strainer
basket inside the juice collector,
making sure the square
center hole sits down over the
square base of the center
plastic screw (Step 2).
3. Place the blade disc inside
the strainer basket and screw it
on using the blade disc
wrench (provided). Do not
over tighten (Step 3).
4. Attach the press plate to
the bottom of the feed tube
by lining up the notches and
the flat edge of the feed tube
with the notches and flat
inside edge of the press
plate. Push the press plate
down and turn clockwise to
snap in place. Note, the
protruding round end of the
press plate will point towards
the pulp outlet (Step 4).
5. Place the cover on the juice
collector with the pulp outlet
facing away from the juice
chute. Pull the handle up and over the top of the cover into the recesses in
the cover. The cover should now be firmly secured (Step 5).
6. Attach the pulp container under the pulp outlet by tilting it and pushing it
forward until it is seated. If the pulp container is not properly seated, the juicer
will not turn on (Step 6).
7. Put the food pusher in the feed tube (Step 7).
8. Plug the electrical cord into the wall socket.
Step 7
Step 5
Step 4
Step 3
Step 3
Step 2
Step 1
Step 6
8
EN

For Pureeing

1. Place the juice collector on the motor
base and align the three tabs in the
juice collector with the recesses on the
motor base (Step 1).
2. Place the puree basket inside the juice
collector, making sure the square
center hole sits down over the
square base of the center
plastic screw
(Step 2).
3. Place the blade
disc inside the puree
basket and screw it on
using the blade disc wrench
(provided). Do not over
tighten (Step 3).
4. Attach the press plate* to
the bottom of the feed tube by
lining up the notches and the
flat edge of the feed tube with
the notches and flat inside
edge of the press plate. Push
the press plate down and turn
clockwise to snap in place.
Note, the protruding round end
of the press plate will
point towards the pulp outlet
(Step 4).
* For pureeing leafy greens
attach the blade disc cover,
rather than the press plate,
to the bottom of the feed tube (Step 4).
5. Place the cover on the juice collector with the pulp outlet facing away from the
juice chute. Pull the handle up and over the top of the cover into the recesses in
the cover. The cover should now be firmly secured (Step 5).
6. Put the puree container inside the pulp container and attach them both under
the pulp outlet by tilting them and pushing them forward until they are
seated. The juicer will not turn on (Step 6).
7. Put the food pusher in the feed tube (Step 7).
8. Plug the electrical cord into the wall socket.
Step 7
Step 5
Step 4
blade
disc
cover
Step 3
Step 2
9
EN
Step 3
Step 6