Assembly; Carton Contents - Craftsman 580.768331 Manual Del Operador

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER FROM
CARTON
• Remove parts box shipped with your pressure
washer.
• Slice two corners oppisite guide handle end of
carton from top to bottom so the panel can be
folded down flat.
• Roll the pressure washer out the open end of the
carton.
Lift the handle to
upright position and
slide the locking caps
into place
• Raise guide handle, secure in place.
• Check carton for additional loose parts.

CARTON CONTENTS

Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
• The main unit
• Parts box (which includes items listed below)
Spray gun
High pressure hose
Nozzle extension with quick connect
Quick connect nozzles
Engine oil
Owner's manual
Nozzle cleaning kit
O-Ring kit

ASSEMBLY

Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to the spray gun and
the pump.
• Connect water supply to the pump.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, or SH rated SAE 30 weight.
Other viscosity oils shown in the chart may be used
when the average temperature in your area is within
the recommended range.
• Place pressure washer on a level surface.
• Clean area around oil fill and remove oil dipstick.
• Wipe dipstick clean. Pour oil into oil fill opening.
Replace and tighten dipstick, remove and and
check oil level. Oil level should be at "Full" mark on
the dipstick. DO NOT OVERFILL.
• Install oil dipstick, hand tighten securely.
NOTE: Check oil often during engine break–in.
4