Pre-Installation - AquaPRO 53041-0 Manual Del Usuario

19. Ensure the electrical power source is adequate for the requirements of the pump.
20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the hose is
not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of water quickly,
and also check that all hose connections are tight to minimize leaks.
21. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
22. This pump is fully automatic in operation. If the water level is over 2 in., the water detector senses water. Then the
control system built in the pump automatically starts the pump and the pump continues to run until water is pumped
down to 3/4 in. deep, and then it stops. If the water level is not over 2 in., the pump will not start.
23. Electric shock hazard! GFCIreceptacles will provide protectionagainst line to ground faults only. The ground
faultreceptacle does NOT limit the magnitude of fault currentand will NOT prevent an electrical shock. Replace
damaged cordimmediately.
24. Risk of electric shock. This pump has NOT been tested for use in marine areas. NEVER place pump in pools while
people are in the water. Do NOT handle pump with wet hands or when standing in water or on a damp surface.
Pump is designed to be used in closed and covered pools only. Water accumulated on pool cover can cause injury
or death. Proper installation of pool cover pump and periodic maintenance is recommended. Failure to follow
COULD result in death or serious injury.
25. The unit MUST be plugged into a properlygrounded GFCI outlet. Consult with a qualifiedelectrician for proper
installation of a GFCI OUTLET.
26.
Do not move, position, retrieve, or carry pumpusing the power cord or the discharge hose, d
cord may occur. Use thehandle supplied on the pump or attach a string to the strainero position as instructed.

PRE-INSTALLATION

APPLICATION
This portable, auto On-Off Pool Cover pump is designed forautomatic removal of water, from a pool or spa cover. The
unitsare equipped with a 25 ft. 3-prong grounding type power cord.The provided discharge check valve prevents short
cycling andit's 3/4"adapter can beused for convenient attachment to astandard garden hose.
Features:

Operating water depth: minimum 2 in.
TOOLS REQUIRED
Flathead
Screwdriver
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
amage to the pump or power
Wrench
Safety
Goggles
3