Pre-Installation; Tools Required; Materials Required (Not Included) - AquaPRO 60013 Manual Del Usuario

PRE-INSTALLATION

APPLICATION
This unit is a single stage jet pump designed for shallow water well applications, where the water level is less than 25 ft.
deep. If the water level to the pump is deeper than 25 ft., a convertible jet pump or a deep well submersible pump should
be used. A pressure switch pre-set at 30 psi "on", 50 psi "off" has been installed on the pump. The pressure switch will
automatically turn the pump on and off based on the system pressure.

TOOLS REQUIRED

Flathead
Screwdriver
Safety goggles

MATERIALS REQUIRED (NOT INCLUDED)

One can PVC cement & primer (read instructions carefully)
One can thread compound (read instructions carefully)
Teflon tape
Rigid pipe
Check valve
Flexible plastic pipe/clamps
Tank tee
WARNING: All joints and connections must be AIRTIGHT. A single leak will prevent the proper operation of the pump.
Wrap thread tape clockwise on all threaded connections. For all non-threaded connections, you must use PVC Purple
Primer and PVC Cement to ensure airtight seals. Measure all pipe lengths before attaching.
NOTE: A foot valve is a check valve that is used to keep the water from running back into the well from the pump and
maintain hydraulic pressure when the pump is not running. If the foot valve does not hold the water the pump will lose it's
prime and will not pump water. If the foot valve open pressure is too high (the spring is too stiff), or the flow area is too
small, the pump suction head and flow rate will significantly drop.
NOTE: For 61013/61023/61033.The suction pipe size should not be less than 1-1/4 in. the suction size of this pumpis
1-1/4 in. FNPT.
For 60013/60023/60033/62013/62023/60043/62033, the suction pipe size should not be less than 1in. the suction size
of this pump is 1 in. FNPT.
Phillips
Screwdriver
Tape Measure
3
Pipe wrench
Thread Tape
One well seal with vent plug
Foot valve
Discharge tee/Priming tee and plug
Relief valve
Adaptor
Tank(for AUTO series tank is included）
Hacksaw
PVC glue