Pre-Installation; Tools Required - AquaPRO 33011-6 Manual Del Propietário

15. Secure the pump to a solid base. This will aid in keeping the pump in a vertical orientation. This is critical in
keeping the pump operating at maximum efficiency. It will also help prevent the pump from clogging resulting
in premature failure.
16. Periodically inspect the pump and system components to ensure the pump suction screen is free of mud,
sand, and debris. Disconnect the pump from the power supply before inspecting.
17. Follow all local electrical and safety codes, along with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA) guidelines must be followed.
The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will
18.
reset itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt,
or debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.

PRE-INSTALLATION

APPLICATION
This submersible sump pump is designed for home sump applications. Use this pump only for pumping

water.
 This unit is not designed as a waterfall or fountain pump, or for applications involving salt water or brine!
Use with waterfalls, fountains, salt water or brine will void warranty.
 Do not use where water recirculates.
Not designed for use as a swimming pool drainer.


TOOLS REQUIRED

Flathead
Screwdriver
Hacksaw
Phillips
Screwdriver
Safety goggles
Cable Ties
3
Channel
Pipe wrench
Locks
Tape Measure