Pre-Installation; Tools Required - AquaPRO 70013 Manual Del Propietário

17. Capacitor voltage may be hazardous. To discharge motor capacitor, hold insulated handle screwdriver BY THE
HANDLE and short capacitor terminals together. Do not touch metal screwdriver blade or capacitor terminals. If in
doubt, consult a qualified electrician.
18. Pump is designed as a lawn sprinkler only.
19. Do not allow pump or any system component to freeze. To do so will void warranty.
20. Pump water only with this pump.
21. Keep work area clean, uncluttered and properly lighted; store properly all unused tools and equipment.
22. Keep vistors at a safe distance from the work areas.
23. "Dead Heading" a pump means running the pump while little or no water is released from the system. Never run
pump above recommended pressure shown on the performance chart.

PRE-INSTALLATION

APPLICATION
This pump is designed for lawn sprinkling. Delivers plenty of water at full sprinkler pressure. Pumps from pond, cistern or
well points.
Pump discharge can be divided to supply 4 or more sprinkler systems.
Don not use in booster pump applications.
To avoid heat built-up, over pressure hazard and possible injury, do not use in a domestic water system. Do not use as a
booster pump; pressurized suction may cause pump body to explode.

TOOLS REQUIRED

Flathead
Screwdriver
Safety
Goggles
SPECIFICATIONS
Power supply
Liquid Temp. Range
Discharge
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
115V/230V, 60 HZ. 70042 is 230 Volts only
32°F to 77°F (0°- 25°C)
1 1/2 in.
Pipe
wrench
Tape
Measure
Hacksaw
Thread
Tape
PVC
glue
3