Options Style 1; User Options - Amana HDC212 Manual Del Usuario

Options
STYLE 1

User Options

Follow the instructions below to customized the
microwave oven's operation. End-of-cycle signal,
maximum cooking time and other options can be
changed to meeting your cooking needs. Example:
Change setting to single digit pad operation.
1. Open oven door.
• If door is closed or STOP/ RESET
pressed before finishing programming sequence,
oven exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"OPTIONS".
Numbered Pads Display
1 OP:10
End of Cycle Beep OP:11
OP:12
2 OP:20
Speaker Volume OP:21
OP:22
OP:23
3 OP:30
Key Beep OP:31
4 OP:40
Keyboard Enable OP:41
Window
OP:42
OP:43
5 OP:50
Add Time during OP:51
Heating
6 OP:60
Reset Door Open
OP:61
7 OP:70
Maximum Heating OP:71
Time
8 OP:80
Manual Operation OP:81
9 OP:90
Double Digit OP:91
Operation
0 OP:00
Clean Filter OP:01
OP:02
Message
OP:03
3. Press 9 pad.
4. Press 9 pad repeatedly to change setting.
5. Press START
pad is
6. Press STOP/RESET
Options ( Factory Settings in Bold)
3 second continuous beep
Continuous beep until door is opened
5 beeps bursts until door is opened
Eliminates beep
Sets volume to low
Sets volume to medium
Sets volume to high
Prevents beep when pad is pressed.
Allows beep when pad is pressed.
15 seconds after oven door is opened, keyboard disabled
30 seconds after oven door is opened, keyboard disabled
1 minute after oven door is opened, keyboard disabled
2 minutes after oven door is opened, keyboard disabled
Prevents adding heating time while oven is heating.
Allows adding heating time while oven is heating when a
memory pad is pressed.
Cancels heating time count down after door is opened during
cycle.
Allows oven to resume heating time countdown after door is
opened during cycle.
Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
Do not display message.
Display message for 24 hours every 7 days.
Display message for 24 hours every 30 days.
Display message for 24 hours every 90 days.
11
• See table for options.
• Displays shows "OP:90".
• "OP" represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
pad to save changes.
• Repeat steps 3-5 to change additional options.
• Changes appear after door is closed or STOP/
RESET is pressed.
to exit programming mode.
pad or close oven door