Installation; Radio Interference - Amana HDC212 Manual Del Usuario

Horno de microondas compacto comercial para uso rudo [0.6 pies cúbicos]
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Unpacking Oven
• Inspect oven for damage such as dents in door or
dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.

Radio Interference

Microwave operation may cause interference to radio,
television. Reduce or eliminate interference by doing the
following:
• Clean door and sealing surfaces of oven according to
instructions in "Care and Cleaning" section.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
Oven Placement
• Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
• Install oven on level countertop surface.
A—Allow at least 7 " (17.8 cm) of clearance around top and
sides of oven. Proper air flow around oven cools electrical
components. With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B—Allow at least 2
/
9
back of oven and back wall.
Oven Clearances
6
" (6.5 cm) between air discharge on
16

Publicidad

Tabla de contenido
loading

Tabla de contenido