Fein Slugger JMC USA 9 Serie Instrucciones De Uso página 15

OBJ_BUCH-0000000276-001.book Page 15 Monday, July 31, 2017 1:42 PM
Changing the tool (figure 6).
Before mounting or replacing
WARNING
cutting tool or accessories,
pull the power plug. This preventive safety
measure rules out the danger of injuries
through accidental starting of the power tool.
Swing out the chip guard to the side.
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex key.
Fig. 6
1.
Fig. 4
5 mm
2.
Hex wrench
3.
5.
5 mm
4.
en
15
Chip guard
2.
Pilot pin
Core drill bit
5.