Fein Slugger JMC USA 9 Serie Instrucciones De Uso página 20

OBJ_BUCH-0000000276-001.book Page 20 Monday, July 31, 2017 1:42 PM
en
20
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Error message/ Meaning
Response of magnet
button
Indicator lights up Magnetic holding power is suf-
green ficient.
Indicator flashes Magnetic holding power possi-
green bly insufficient.
Indicator lights up red – Motion sensor has actuated
for 1 second – Overload shut-off has actu-
– Incorrect mains voltage
Indicator flashes red
3 x
Indicator lights up red – Incorrect mains volt-
continuously
– Drill stand is overheated
– Button is blocked when
Indicator flashes red Power tool is defective.
continuously
temperatures. Do not touch the magnet with
your bare hands.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
For adjustment of the drill spindle when tap-
ping, only use the provided T-handle hex
wrench or a hex key.
ated
No speed signal
age/mains frequency
switching on
Danger of burns! The surface
CAUTION
of the magnet can reach high
Corrective action
Even when working on steel materi-
als where the material thickness is
below 12 mm, the workpiece must
be made thicker with an additional
steel plate in order to ensure the
magnetic holding power.
After malfunction correction, the
power tool can be switched on again.
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
After malfunction correction, the
power tool can be switched on again.
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
Send the machine to your Slugger
customer service agent