Fein Slugger JMC USA 9 Serie Instrucciones De Uso página 18

OBJ_BUCH-0000000276-001.book Page 18 Monday, July 31, 2017 1:42 PM
en
18
For switching the magnet ON
(figure 10).
Please make sure that the contact surface-
for the magnetic base is level, clean and
rust-free. Remove any varnish or primer.
When working, always use the magnetic
base; ensure that the magnetic holding
power is sufficient.
When working on materials that are non-fer-
rous, suitable fixation devices obtainable as
accessories from the manufacturer, e. g. suc-
tion plates, vacuum plates or pipe-drilling
devices must be used.
When working on steel materials with a
material thickness of less than 12 mm /
the workpiece must be reinforced with an
additional steel plate in order to guarantee the
magnetic holding power.
Press the magnet switch to energize the mag-
net.
Fig. 10
=
1
/ in,
2