XYZ Printing PartPro200xTCS Manual Del Usuario página 23

Scanning
The limitations of the object to be scanned
•
The object should be stable and stationery. It must not be shaken or moved during the rotation of the turntable.
•
Scan area for the object mode is 5cm ϕ x 5 cm – 14cm ϕ x 14 cm (H).
•
The object should not be reflective, tranparent, or translucent ones.
•
The object with a reflective surface, metal, or transparent material will have an impact on the scanning quallity. If you
want to scan an object like this, it is recommended to spray the developer on the surface before scanning it.
•
If the object has a solid color, or does not have obvious textures or an obvious shape, you may not have the best scan-
ning results.
•
The round object will have scanning results, while the slime and long or sharp objects won't have good scanning re-
sults.
Scan steps - Install the scan backboard
1. Remove the object from the
tumtable.
Scan steps
1. Select the scan module in the
Settings.
5. Pleace the object to be
scanned.
2. Wait until the scan turntable
returns.
Insert the two sides at the
bottom of the scan backboard
into the holes and secure them.
2. Empty the printer platform.
6. The object is being scanned.
3. Install the scan backboard.
Direction of the latch.
3. Install the scan backboard.
7. When the scan is completed,
you can finish the scan job and
perform other jobs.
The installation of the scan
backboard is completed.
4. Wait until the printer platform
returns.
P23 P23