XYZ Printing PartPro200xTCS Manual Del Usuario página 6

Unpacking and Installation
10
Ensure that the one end of guide tube(Accessory 8) has been tightly. inserted into the printing module
port, then insert the other end into the clear tube (Accessory 13) to the end.
11
Feed the guide tube through the top cover then attach the
top cover to the machine.
13
Please follow the order as image instruction, attach the PC
mylar (accessory 9) and mask tape(accessory 10) on the EZ
removable rubber magnet(accessory 6).
14
Confirm the rubber magnet is well placed on the print bed.
Precautions
1. Check if the print bed calibration screws
was stuck.
Mask Tape
PC Mylar
EZ Removable
Rubber Magnet
2. Used to 2 thumb to push up the printbed
to release the calibration screw.
12
Insert the other end of the guide tube into the feed module
and secure it tightly.
Note
There is a sheet of PC film to
rubber magnet with a double
sided adhesive, this PC film is
replaceable, please replace it
when it's dirty or broken.
P6 P6